Readers Comments (28)

  1. you now sensor hall 503 found case to 49e?

  2. William Vanderpool November 25, 2020 @ 7:01 pm

    out standing wow great to know thanks for the video two thumps up .

  3. THANK YOU
    Your videos are best, Best channel about E.V ebike.

  4. Well done exactly right thanks.

  5. One Wheel Appeal November 25, 2020 @ 7:04 pm

    How come this guy has a woman’s voice

  6. IMEDIA PURWOKERTO November 25, 2020 @ 7:04 pm

    good idea,.. thanks my boss

  7. But if throttal volt from 0.8v to 3.6 v is it rgiht or not thanks

  8. The comments are very good. I had my experience with the Aston Rider kit, it came out less than 300usd with lifepo battery and it has been running without problems since I had it more than a year ago

  9. hello friend good video, but you still haven’t looked at me how to convert a pas sensor as if it were an accelerator?

  10. What happened to the šŸ¦?

  11. This is the kind of video e-bike people can really use. Thank you.

  12. Very nice video

  13. I need controler diagram for motor 24v 250w

  14. Revive Electric Bikes November 25, 2020 @ 7:29 pm

    How do we recognise which wire is positive, negative and return current? Is anything marked on the sensor as well?

  15. how could i do this. i want to be able to disable the throttle with a switch but an error code happens if i cut off the red or green cable. i want to be able to just have the pas and not throttle. any advice please?

  16. Great video…exactly what I needed, to fix my electric scooter.

  17. Hassan Aitoufkir November 25, 2020 @ 7:38 pm

    Clear and to the point.
    Thank you!

  18. Does the brushless motor controller support different hall sensor numbers or they must be a. Specific one.

  19. well done master, there are a lot of interest points in this video.1) the good position and good skill for welding 2) the good phases for checking an electronic tool 3) the importance of grease and a lot of other informations, thank you very much.

  20. I hadn’t even considered this is what might be wrong with my scooter. Nice video, I’m gonna test this today

  21. Could you do an installation guide for this exact throttle? Iā€™ve owned one of these for a while and couldnā€™t figure it out. Thanks a bunch!

  22. Thank you.

  23. I hope you can make videos how to install lights direct to controller with explanations. for 36v,48 and 60v. because for all I know, most lights are 12v. some are autovolt. but since I want to change the controller and lcd, the lights has no indication what voltage it is. and the controller doesn’t just accepts any voltage.i am afraid I might damage either the controller or light. what will I do? some says, buy converter or some says, just connect it to series,..but let’s say I wanna preserve the stock lights yet I don’t know what voltage are the frint and rear light.. what will I do?thanks

  24. āœ…šŸ‘NICEšŸ‘āœ…

  25. I need help reconnecting a new controller. Can you help me.?

  26. I can’t see sensor number on my bike throttle it is microscopic. So if I buy this hall sensor from the link you have provided, will it work in my bike?

  27. genau das Auseinander Bigen ist immer schuld das die Kaput gehen alle Brutscher

  28. Why is it only 4.29V max?

Leave a comment

Your email address will not be published.


*